Your Independent Project

You can use Arduino directly on several projects, but you can also create them independent of your Arduino board, that is, by creating a Standalone project, using only the ATmega micronator already written and tested with the required code, and a few components required for its operation.

We at the Digital Institute have tested and suggested this simple scheme of a standalone project, we have produced a simple graphic scheme so that you can better understand its operation.
Feel free to swap or remove components you find necessary. Watch out for voltage and voltages so as not to damage its components.

List of components used:

1 Plug jack type P4 DC female 2.5mm
1 Diode 1N4001
1 Touch switch
2 Electrolytic Capacitors 10uf 25v
2 Ceramic Capacitors 22pf
1 Voltage regulator 7805 5v
1 x 28-pin integrated circuit socket
1 Resistor 470 ohms
1 Resistor 10k
1 16,000 Mhz crystal oscillator
1 Led 5mm

* This project is only a suggestion, we are not responsible for any problems or defects that may occur